 -
- Looks
Best In 800x600
-
|
|
- HackersCatalog.com
Technical notes section is an online guide to
help in answering some general questions, at
no time will we answer questions on how to
use our products or information for illegal
purposes. All information sold on
HackersCatalog.com is for educational
purposes only.
-
-
-
|
- Technical
Notes:
-
- CABLE BOX
Diagrams
-
- Every
Electronics magazine or Internet Search
Engine listing has an advertisement on how to
build your own cable TV descrambler for $15
or less. Save your money. Presented here is
what you get for the money. These are the
plans. Typically for a notch filter for the
interference scrambling method. This system
is estimated by the FBI to be used by less
than 7% of the cable companies today. Save
yer dough…
-
-
- PAY TV
DECODER PLANS
-
-
-
- MATERIALS
REQUIRED
-
- 1 - Radio
Shack mini-box ( #270-235)
- 1 - 1/4 watt
resistor, 2.2k-2.4k ohm
- (RS
#271-1325)
- 1 -
75pf-100pf variable capacitor
- (Hard to
find)
- 2 - F61a
chassis-type coaxial
- connectors
(RS #278-212)
- 12" - No. 12
solid copper wire
- 12" - RG59
coaxial cable
-
-
-
- INSTRUCTIONS
-
- 1. Bare a
length of No. 12 gauge solid copper wire and
twist around a 3/8 nail or rod to form a coil
of 9 turns. Elongate coil to a length of 1
1/2 inches and form right angle bends on each
end.
-
- 2. Solder
the variable capacitor to the coil. It
doesn't matter where you solder it, it still
does the same job The best place for it is in
the center with the adjustment screw facing
upward.
-
- Note: When
it comes time to place coil in box, the coil
must be insulated from grounding. This can be
done by crazy gluing a piece of rubber to the
bottom of the box, and securing the coil to
it.
-
- 3. Tap coil
at points 2 1/2 turns from ends of coil and
solder to coaxial chassis connectors,
bringing tap leads through holes in chassis
box. Use as little wire as possible. 4.
Solder resistor to center of coil and ground
other end of resistor to chassis box, using
solder lug and small screw.
-
- 5. Drill a
1/2" diameter hold in mini-box cover to
permit adjustment of the variable capacitor
from the outside. Inspect the device for
defects in workmanship and place cover on
mini-box. Tighten securely.
-
- 6. Place
device in line with existing cable on either
side of the converter box and connect to
television set with the short piece of RG59
coaxial cable. Set television set to HBO
channel.
-
- 7. Using a
plastic screwdriver (non-metallic)adjust the
variable capacitor until picture tunes in.
Sit back, relax, and enjoy!!! (HAR)
-
-
-
-
-
- SEE
NOW, AREN'T YOU GLAD YOU SAVED THE
MONEY?
-
|
|
|
